UpDown Desk PRO Series Install Manual page 14

S-1 - Unit Displayed Change - Changes the number display from 'cm' to 'inch'.
When S-1 is showing on screen
Click 'M4'
From there you can use the arrows to select either of the following
0 - Cm
1 - Inch
Clicking 'M4' will return you to the height display screen.
S-2 - Blank Function
S-3 - Up Anticollision sensitivity - This will adjust the sensitivity of the anticollision when the
desk is in 'Up' motion.
At function menu - 'S-1' is shown, use the up arrows to get to 'S-3'
Click 'M4'
Use the 'Up' and 'Down' arrows to increase or decrease sensitivity
Note: 1 = Most Insensitive 8 = Most Sensitive
Once adjusted, Click 'M4' to return to the height display screen.
S-4 - Down Anticollision sensitivity - This will adjust the sensitivity of the anticollision when
the desk is in 'Down' motion.
At function menu - 'S-1' is shown, use the up arrows to get to 'S-4'
Click 'M4'
Use the 'Up' and 'Down' arrows to increase or decrease sensitivity
Note: 1 = Most Insensitive 8 = Most Sensitive
Once adjusted, Click 'M4' to return to the height display screen.
S-5 - Setting Low Display Height - This functionality allows the user to adjust the height
displayed on the screen - this would be utilised when the user has put a thicker desktop onto
the frame than the standard 25mm.
At function menu - 'S-1' is shown, use the up arrows to get to 'S-5'
Click 'M4'
Use the 'Up' and 'Down' arrows to change the height that you would like to set.
Once adjusted, Click 'M4' to return to the height display screen.
14