Siemens SIMATIC NET RUGGEDCOM RX1536 Equipment Manual page 33

Device Management
3.1 Connecting to the Device
Serial Console and Management Ports
Connect a workstation directly to the serial console or management ports to access
the boot-time control and RUGGEDCOM RX1536 interfaces. The serial console port
provides access to RUGGEDCOM RX1536's console interface, while the management
port provides access to RUGGEDCOM RX1536's console and Web interfaces.
The serial console port implements RS232 DCE (Data Communication Equipment) on
a DB9 connector. The following is the pin-out for the port:
Figure 3.2
For information about how to connect to the device via the serial console port, refer
to the "RUGGEDCOM ROX II CLI Configuration Manual" for the RUGGEDCOM RX1536.
For information about how to connect to the device via the management port,
refer to either the "RUGGEDCOM ROX II Web Interface Configuration Manual" or the
"RUGGEDCOM ROX II CLI Configuration Manual" for the RUGGEDCOM RX1536.
The management port is a 10/100Base-TX copper Ethernet port with an RJ-45
connector. The following is the pin-out for the management port:
8
Figure 3.3
24
1
5
9
6
Serial DB9 Console Port
Pin
1
2
3
4
5
6
7
8
9
1
RJ-45 Management Port
Pin
1
Name
DCD
RX
TX
DTR
GND
DSR
RTS
CTS
Reserved (Do Not Connect)
Name
RX+
Description
Data Carrier Detect
Receive Data
Transmit Data
Data Terminal Ready
Signal Ground
Data Set Ready
Request to Send
Clear To Send
Description
Receive Data+
RUGGEDCOM RX1536
Equipment Manual, 10/2023, C79000-G8976-1488-07