2.5.2
Debug Port Settings
RSB-3730 can communicate with a host server by using serial cables. Common
serial communication programs such as HyperTerminal, Tera Term or PuTTY can be
used in this case. The example below describes the serial terminal setup using
HyperTerminal on a Windows host:
1.
Connect RSB-3730 to your PC by using a serial cable.
2.
Open HyperTerminal on your Windows PC, and select the settings as shown in
Figure 2-7.
3.
After the bootloader is programmed on the SD card, connect the power adapter
connector to the DC jack on RSB-3730 to power up the board. The bootloader
prompt will be displayed on the terminal screen.
Figure 2.20 HyperTerminal Settings for Terminal Setup
27
RSB-3730 User Manual