Chapter 8 - Labels; Approvals And Certifications; Example Labels - Multitech SocketModem Cell Cat M1 Device Manual

Chapter 8 – Labels

Approvals and Certifications

This device is an industry and/or carrier approved modem. In most cases, when integrated and used with an
antenna system that was part of the MultiTech modem certification, additional approvals or certifications are not
required for the device that you develop as long as the following requirements are met:
PTCRB Requirements: The antenna system cannot be altered. The antenna system must be the same type
with similar in-band and out-of-band radiation patterns and maintain the same specifications. Refer to the
FCC grant information for details.
Model Identification: The MultiTech model identification allows the carrier to verify the modem as one of
its approved models. This information is located on the modem's label below the bar code.

Example Labels

Note: Actual labels vary depending on the regulatory approval markings and content.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The label shown is not than actual size.
1. MultiTech Model Identification
2. MultiTech Ordering Part Number
3. IMEI (International Mobile Equipment Identity).
®
SocketModem Cell Cat M1 MTSMC-MNG6 Device Guide
MTSMC-MNG6 Device
Label
MTSMC-MNG6-U Device
Label
LABELS
31