Page 1
® SocketModem MTSMC-G1 Hardware Guide for Developers...
Page 2
Phone: 763-785-3500 or 800-328-9717 Fax: 763-785-9874 Internet Address: http://www.multitech.com Technical Support Country By Email By Phone Europe, Middle East, Africa: support@multitech.co.uk +(44) 118 959 7774 U.S., Canada, all others: support@multitech.com 800-972-2439 or 763-717-5863 Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Quad-band GSM/GPRS SocketModem - Symstream Enabled - Global External Power (900/1800 MHz Default) How to Read the Table Above Build Description GSM/GPRS Euro Default, 900/1800 MHz Symstream Enabled External Power Source Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
To be determined at a later date. Safety Certifications Approvals UL 60950 cUL 60950 EN 60950 AS/NZS 60950:2000 EMC Approvals FCC Part 22, 24 ETSI EN 301 489-7 Network PTCRB Warranty Two years Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Chapter 1 – SocketModem GSM SocketModem Configuration Serial Configuration Note: The bolded, shaded pins are the SocketModem GSM active pins. Top View SocketModem Pinout Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Page 8
Logic Ground. DC Input Power. 5V DC power. Analog Ground. Analog ground is tied common with DGND on the SocketModem. To minimize potential ground noise issues, connect audio circuit return to AGND. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Power Consumption in GSM/GRPS 1800 MHz and GSM/GRPS 1900 MHz Class 10 Conditions During TX bursts @ 1W 1.1 A peak 1.2 A peak Average @ 1W 350mA 400mA Average @ 0.25W 180mA 210mA Average idle mode 15mA 25mA Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Frequency error : ± 0.1 ppm max RF Connection The RF connector on the SocketModem GSM is a UFL standard type. An antenna can be directly connected through a mating UFL to SMA adapter. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Chapter 1 – SocketModem GSM Upgrading Firmware Upgrading the Firmware will be addressed in a later revision of this document. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
SMA to UFL COAX RF 6 inch cable (Single Pack) CASMA-UFL-10 SMA to UFL COAX RF 6 inch cable (Ten Pack) Cable Specifications Cable Type: Dia. 1.13mm Coaxial Cable Attenuation: <1.0db Connector Impedance: 50 ohm Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Page 13
MHz for mobile operating configurations and 7.1 dBi at 1900 MHz / 0.9 dBi at 850 MHz for fixed mounted operations, as defined in 2.1091 and 1.1307 of the rules for satisfying RF exposure compliance. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
It is imperative that specific designs be completely evaluated by a qualified/recognized agency. *DAA stands for Data Access Arrangement. DAA is the telephone line interface of the module. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Multi-Tech uses and recommends that others use anti-static boxes that create a faraday cage (packaging designed to exclude electromagnetic fields). Multi-Tech recommends that you use our packaging when returning a product and when you ship your products to your customers. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Switch OFF your wireless modem in hospitals and any other place where medical equipment may be in use. • Respect restrictions on the use of radio equipment in fuel depots, chemical plants or where blasting operations are in progress. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Page 17
It is not a toy. Therefore, keep it in a safe place at all times and out of the reach of children. Try to remember your Unlock and PIN codes. Become familiar with and use the security features to block unauthorized use and theft. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Model Identification IMEI (International Mobile Equipment Identity) • Other Information the Wireless Carrier Asks You to Provide: The modem's 15-character IMEI (International Mobile Equipment Identity) number printed on the modem's label. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Reglement Canadien sur le matériel brouilleur. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
For more information about where you can drop off your waste equipment for recycling, please contact your local city office, your household waste disposal service or where you purchased the product. July, 2005 Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Moisture Sensitivity Level (MSL) – Analysis is based on the components/material used on the board. Tin Whisker Study was done per NEMI guidelines (Elevated temperature cycle of 60°C and non- condensing relative humidity of 87% exposed to this environment for 1000 hours). Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Represents that the concentration of such hazardous/toxic substance in all the units of homogeneous material of such component is higher than the SJ/Txxx-2006 Requirements for Concentration Limits. Represents that no such substances are used or that the concentration is within the aforementioned limits. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Chapter 5 – The SocketModem Developer Board The Developer Board Components See the next page for a description of the Board Components. Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Sets the alternate ISDN clock. Default position is OFF (the alternate ISDN clock is off). Switch Block Set the switch to the product being used. Pins and Corresponding Signals J4 and J7 10 PWR J2 and J13 Multi-Tech Systems, Inc. SocketModem GSM Hardware Guide for Developers...
Please direct your questions regarding technical matters, product configuration, verification that the product is defective, etc., to our Technical Support department at (800) 972-2439 or email support@multitech.com. Please direct your questions regarding repair expediting, receiving, shipping, billing, etc., to our Repair Accounting department at (800) 328-9717 or (763) 717-5631, or email mtsrepair@multitech.com.
Page 33
Please direct your questions regarding technical matters, product configuration, verification that the product is defective, etc., to our Technical Support department nearest you or email support@multitech.com. When calling the U.S., please direct your questions regarding repair expediting, receiving, shipping, billing, etc., to our Repair Accounting department at +(763) 717-5631 in the U.S.A., or email mtsrepair@multitech.com.