Uninstalling Connection Manager - Multitech SocketModem Cell Cat M1 Device Manual

Table of Contents

Advertisement

USING CONNECTION MANAGER
Note:
Settings displayed for a USB device on the Settings tab are determined automatically and cannot
be changed.
To set the application to run during Windows startup, check Run application at Windows startup.
To automatically connect to the Internet, check Connect to the Internet automatically.
Selecting Run application at Windows startup and Connect to the Internet automatically is useful in
scenarios where Connection Manager is running on a remote computer. If a power failure occurs on the
computer, these settings ensure the application will restart and reconnect to the Internet when power is
restored.
5.
On the Main tab, click Connect.
When a connection is established, the Main tab displays the download and upload speeds, the amount of
traffic sent and received, Connected status, and the signal strength percentage and bars. The statistics on
connection speeds and traffic are available only during a current connection session.
Note:
For serial modems, the signal strength is available only when the device is not connected to the
carrier's network. When connection to the network is established, the last signal strength value is
displayed.
View the details for the current connection on the Details tab.
To disconnect the device from the carrier's network, click Disconnect.
Important:
Disconnect the device in Connection Manager before disconnecting a device from the
computer.

Uninstalling Connection Manager

Along with uninstalling Connection Manager, the installed device drivers are also removed.
Before You Begin
Make sure that Connection Manager is not running.
To uninstall Connection Manager:
1.
In Windows, go to Control Panel > Programs > Programs and Features.
2.
Right-click MultiTech Connection Manager and select Uninstall.
3.
Click Yes to confirm that you want to uninstall Connection Manager.
The native Windows WWAN AutoConfig service is automatically enabled.
4.
When the message "Are you sure you want to uninstall this product?" appears, click Yes.
Connection Manager and the installed drivers are removed from the computer.
Note:
The steps above describe how to uninstall Connection Manager using Control Panel. You can also
uninstall the application by using the installer file (.msi). Double-click the file, in the MultiTech Connection
Manager Setup Wizard, click Next, and then select Remove on the next two pages.
44
®
SocketModem
Cell Cat M1 MTSMC-MNG6 Device Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mtsmc-mng6Mtsmc-mng-spMtsmc-mng6-u

Table of Contents