Table of Contents
Advertisement
www.ti.com
3.1.5.1 DLP650NEEVM/DLP670REEVM Connectors
Reference Designator
J1
J2
J500
3.1.5.2 DLP650NEEVM/DLP670REEVM Test Points
Reference Designator
TP[0:15]
TP25-TP32
3.2 Power Supply Requirements
3.2.1 External Power Supply Requirements
The DLPC4430EVM does not include a power supply. The external power supply requirements are:
•
Nominal voltage: 12-V DC -5%/+10%
•
Maximum Output Current: 7 A
•
DC connector size:
– Inner diameter: 2.5 mm
– Outer diameter: 5.5 mm
– Shaft: 9.5-mm female, center positive
•
Efficiency level: V
•
A recommended power supply is
•
Digi-Key part number
External Power Supply Regulatory Compliance Certifications: Recommend selection and use of an
external power supply, which meets TI's required minimum electrical ratings in addition to complying
with applicable regional product regulatory and safety certification requirements such as (by example)
UL, CSA, VDE, CCC, PSE, and so forth.
DLPU127 – DECEMBER 2023
Submit Document Feedback
TP16
TP18
TP19
TP20
TP21
TP22
TP23
TP24
TP33
TP34
TP35
TP36
TP37
TP38
993-1009-ND, or equivalent
Copyright © 2023 Texas Instruments Incorporated
Description
3.3V to EN_OFFSET
Power (Ext)
FMC Connector
Note
DLP
®
Display ≥0.47-in Array WUXGA/1080p/WXGA/XGA/SVGA Evaluation
Physical Connection Type
Jumper (short)
Cable (Unpopulated)
Cable
Description
MBRST[0:15]
DMDSPARE0
SSP_DAD2CSZ
SSP_DAD1CSZ
VOFFSET
VRESET
BIST_A
BIST_B
TEMP
GND
VBIAS
M_SSP1_CLK
M_SSP1_TXD
M_SSP1_CSZ0
M_SSP1_RXD
MODE_B
Module
Hardware
27
Advertisement
Table of Contents
