Installing The Cooking Components; Placing The Grease Bucket; 11. Connecting To A Power Source - Pit Boss 440D2 Assembly And Operation Manual

9. INSTALLING THE COOKING COMPONENTS

Parts Required:
1 x Upper Cooking Rack (#1)
2 x Cooking Grids (#2)
Flame Broiler Slider (#6)
1 x
Flame Broiler Main Plate (#7)
1 x
Installation:
NOTE: Both flame broiler parts are lightly coated with oil to avoid
rusting when shipped.
• Insert the flame broiler main plate into the main grill, right side first.
Rest the flame broiler main plate on the built-in ledge (on the inside
right) of the main grill that directs grease towards the grease bucket.
Slide the entire piece to the left side, and the two slots on the flame
broiler main plate will fit into the rounded ledge above the fire pot. It
will sit slightly at a downward angle. Note illustration 9A.
IMPORTANT: If the flame broiler main plate is on the base of the
barrel, it is installed incorrectly. The flame broiler should sit at an
angle, with the left side sitting higher than the right.
• Place the flame broiler slider on top of the flame broiler main plate,
covering the slotted openings. Ensure the raised tab is on the left, to easily
adjust for direct or indirect flame when cooking. Note illustration 9B.
NOTE: When the flame broiler slider is open, and direct flame is used
while cooking, do not leave the grill unattended for any period of time.
• Place the cooking grids, side-by-side, on the grid ledge inside the
main barrel. Place the upper cooking rack on the upper ledge inside
the main barrel. Note illustration 9C.
NOTE: To maintain the searing and grilling performance of your
cooking grids, regular care and maintenance Is required.

10. PLACING THE GREASE BUCKET

Parts Required:
1 x Grease Bucket (#16)
Installation:
• Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills. The unit is now
completely assembled.

11. CONNECTING TO A POWER SOURCE

NOTE: Before plugging your Pit Boss® into any electrical outlet,
ensure the temperature dial is in the OFF position.
• STANDARD OUTLET
This appliance requires 110-120 volt, 60hz, 275w, 5 amp service. It must
be a 3-prong grounded plug. Ensure grounded end is not broken off
before use. The control uses a 5 amp, 110-120 volt, fast-blow fuse to
protect the board from the igniter.
10
9A
9B
6
7
9C
1
2
10
7
16