Installing The Cooking Components - Pit Boss PB820ME Manual

8. INSTALLING THE COOKING COMPONENTS

Parts Required:
2 x Cooking Grid A (#3)
1 x Cooking Grid B (#4)
Upper Cooking Rack (#1)
1 x
Flame Broiler Main Plate (#6)
1 x
1 x Flame Broiler Slider (#5)
1 x Flame Broiler Adjusting Bar (#18)
1 x Flame Broiler Adjusting Bar Handle (#17)
Installation:
NOTE: Both flame broiler parts are lightly coated with oil to avoid rusting
when shipped.
• Insert the flame broiler main plate into the main grill, right side first. Rest
the flame broiler main plate on the built-in ledge (on the inside right) of the
main grill that directs grease towards the grease bucket. Slide the entire
piece to the left side, and the two slots on the flame broiler main plate
will fit into the rounded ledge above the fire pot. It will sit slightly at a
downward angle. Note illustration 8A.
IMPORTANT: If the flame broiler main plate is on the base of the barrel, it
is installed incorrectly. The flame broiler should sit at an angle, with the
left side sitting higher than the right.
• Place the flame broiler slider on top of the flame broiler main plate, covering
the slotted openings. Ensure the raised tab is on the left, to easily adjust for
direct or indirect flame when cooking. Note illustration 8B.
NOTE: When the flame broiler slider is open, and direct flame is used
while cooking, do not leave the grill unattended for any period of time.
• Insert the flame broiler adjusting bar through the opening on the left
panel of the main barrel. Slide the notched end of the adjusting bar into
the raised tab on the flame broiler slider, giving you adjustable access to
the slider on the main plate. Note illustration 8C.
• The installation flame broiler adjusting bar handle. Note illustration 8D.
• Place the cooking grids, side-by-side, on the grid ledge inside the main
barrel. Place the upper cooking rack on the upper ledge inside the main
barrel. Note illustration 8E.
NOTE: To maintain the searing and grilling performance of your cooking
grids, regular care and maintenance Is required.
10
8A
8B
5
6
8C
A
B
A
18
B
8D
18
17
8E
3
4
3
6
1