ACME ARAS User Manual page 8

Channel Mode
, press the ENTER button. Use the DOWN and UP button to select the channel mode
Select the
(4CH/ 6CH/9CH). Once the address has been selected, press the ENTER button to setup or exit menu
mode without any change after 8 seconds automatically. Back to the previous functions without any
change press the MENU button.
Dimmer Mode
Select the , press the ENTER button. Use the DOWN and UP button to select
Mode 1)...
mode without any change after 8 seconds. Back to the functions without any change press the MENU
button again.
Dimmer mode 1
Optically Linear
Mode 1(Optically Linear): The increase in light intensity appears to be linear as DMX value is increased.
Mode 2(Square Law): Light intensity control is finer at low levels and coarser at high levels.
Mode 3(Inverse Square Law): Light intensity control is coarser at low levels and finger at high levels.
Mode 4(S-cure): Light intensity control is finger at low levels and high levels and coarser at medium
levels.
Dimmer Speed
Select the , press the ENTER button. Use the DOWN and UP button to select
(Smooth). Once selected, press the ENTER button to setup or exit menu mode without any
change after 8 seconds. Back to the functions without any change press the MENU button again.
(Dimmer Mode 4). Once selected, press the ENTER button to setup or exit menu
Dimmer mode 2
Square Law
Dimmer mode 3
Inverse-Square Law
7A
(Dimmer
Dimmer mode 4
S-Curve
(Fast) or