Table of Contents
Advertisement
The position of the binding holes refers not to the position in which the original is placed on
the platen glass, but to the position of the binding holes viewed when the surface of the
original that you want to scan is face up, with its top edge aligned with the top left corner of
the platen glass.
4
Set the desired binding erase width using "–" or "+," and press "OK"
→
press "Done."
When entering values in millimeters, you can use
Even when you enter the values with
using "–" or "+."
The specified mode is set and the display returns to the Basic Features screen.
If you enter a value outside the setting range, a message prompting you to enter an
appropriate value appears in the screen.
NOTE
•
If you want to enter values in millimeters, press "mm."
•
The default setting is 3/4" (18mm).
5
Press
(Start).
Copying starts.
NOTE
To cancel the setting, press "Special Features" → "Frame Erase" → "Cancel," in this order.
•
•
To cancel all settings and return the machine to the Standard mode, press
Erasing Shadows and Frame Lines from Copies (Frame Erase)
-
(numeric keys) and
-
(numeric keys), you can change the values
2
(Clear).
(Reset).
2-33
Advertisement
Table of Contents
