Table of Contents
Advertisement
4
Press each key: "Top," "Left," "Center," "Right," and "Bottom"
the desired book frame erase width using "-" or "+"
"Done."
When entering values in millimeters, you can use
Even when you enter the values with
using "–" or "+."
The values set here are specified independently for all sides around the original. To set the
same value for all sides around the original, press "Adjust All At Once."
When you select "Adjust All At Once," enter the value using "-" or "+," and press "OK."
The specified mode is set and the display returns to the Basic Features screen.
If you enter a value outside the setting range, a message prompting you to enter an
appropriate value appears in the screen.
NOTE
•
If you want to enter values in millimeters, press "mm."
•
The default settings are 3/8" (10mm) for "Center" and 1/8" (4mm) for "Top," "Left," "Right"
and "Bottom."
•
If you select "Adjust Each Dim.," then you want to set a value uniformly around the original,
press "Adjust All At Once."
Erasing Shadows and Frame Lines from Copies (Frame Erase)
-
(numeric keys) and
(numeric keys), you can change the values
-
→
set
→
→
press "OK"
(Clear).
2-31
2
Advertisement
Table of Contents
