Honda VFR800F 2014 Service Manual page 228

CLUTCH/STARTER CLUTCH
INSTALLATION
Install the
clutch
outer guide
[1] onto the mainshaft and
fit it into the oil pump drive sprocket.
Apply engine oil to the
clutch outer needle
bearing,
primary drive
gear
and driven gear teeth.
lnstall the needle bearing
[2].
AIign the primary drive gear and sub-gear teeth with
a
screwdriver [3], and
install the clutch outer
[4].
Fit the bosses [5] of the oil pump drive sprocket to
the
holes [6] in the clutch outer while turning the
oll pump
driven sprocket.
NOTE:
.
Make sure the
side
surfaces
[7]
of the primary drive
and driven gears are flush.
lnstall the
clutch center
[1].
lnstall
the
lock washer [2] with the
"OUT" mark
[3]
facing
out.
Apply
engine oil to the
threads
and
seating surface of
a
new clutch center lock nut
[1].
lnstall the
clutch center lock nut onto
the mainshaft.
Hold the
clutch center [2] with the
special tool
and
tighten the
lock nut to
the
specified torque.
TOOL:
[3] Clutch center holder
07724-0050002 or
equivalent
commercially
available in
U.S.A.
11-12
TORQUE:
128 N.m (13.1 kgf.m, 94lbf.ft)