Siemens SIMOTICS T-1FW6 Configuration Manual page 476

Installation drawings/Dimension drawings
10.2 Information on the installation drawings
Installation dimensions
For the design, pay special attention to the following dimensions.
L_St
L_Ro
Figure 10-2
Note
Motor dimensions
Siemens reserves the right to change the motor dimensions as part of design improvements
without prior notification. The dimension drawings provided in this documentation, therefore,
may not necessarily be up to date.
You can request up-to-date dimension drawings at no charge.
Position tolerance for fastening holes
The position tolerance for fixing holes is defined in DIN EN ISO 1101:2008-08.
Maintain the position tolerance when drilling fixing holes in the machine assembly.
If no other value is specified, the standard position tolerance of ∅ = 0.2 mm (as used by the
machine tool industry) applies.
474
Stator length
Rotor length
Stator length and rotor length of 1FW6 built-in torque motors
1FW6 Built-in torque motors
Configuration Manual, 09/2022, A5E52220645B AA