Prepare Dishwasher - Kenmore 66513734K604 Installation Instructions Manual

Option 2, No waste disposer - with air gap:
]. Cut end of drain hose if needed (do not cut ribbed section).
2. Attach drain hose to air gap with large spring-type clamp. If
the drain hose was cut, use a 11/2" to 2" (3.8 to 5 cm) screw-type
clamp*.
3. Use a rubber hose connector* with spring or screwtype clamps*
to connect air gap to waste tee.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor where dishwasher will be installed.
Drain hose -
cut here if needed
Rubber hose
connector
rf
Air gap
Spring or
screw-type
clamps
Large
spring-type
clamp
Drain
Drain trap hose
4, Insert drain hose through
hole cut in cabinet to the
Drain hose
front center of opening
where drain connection will
be made.
*Parts available from local
plumbing supply stores.
Option 3, Waste disposer - no air gap:
J. Remove the disposer knockout plug. Do not cut end of drain
hose.
2. Attach drain hose to disposer inlet with large springtype clamp.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor where dishwasher will be installed. It
is recommended that the drain hose be looped up and securely
fastened to the underside of the counter.
3. Insert drain hose through
hole cut in cabinet to the
front center of opening
where drain connection will
Drain hose
be made.
Option 4, No waste disposer - no air gap:
]. Cut end of drain hose if needed (do not cut ribbed section).
2. Attach drain hose to waste tee with 1/2" to 2" (3.8 to 5 cm)
screw-type clamp*.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor where dishwasher will be installed. It
is recommended that the drain hose be looped up and securely
fastened to the underside of the counter.
Drain hose -
cut here if needed
Screw-type
clamp
Drain trap
3. Insert drain hose through
hole cut in cabinet to the
front center of opening
where drain connection will
be made.
*Parts available from local
plumbing supply stores.
%
x , 9 ao bene, & mo be ens
Prepare Dishwasher
AWARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
AWARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Helpful Tip: Put cardboard under dishwasher until it is installed
in cabinet opening. The cardboard will help avoid damage to
floor covering during installation.
Using 2 or more people, grasp the sides of dishwasher door
frame and put the dishwasher on its back, resting on top of the
corner posts.
Remove two screws attaching access panel and lower panel to
dishwasher using a Y4" hex socket, nut driver or Phillips
screwdriver.