Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS
IMPORTANT: Always use a new drain hose when installing a new
Y
replacement dishwasher.
1.
Drill a 1%" (3.8 cm) diameter hole in cabinet wall or floor on
the side of the opening closest to the sink.
Electrical Shock Hazard
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
Failure to do so can result in death or electrical shock.
2.
Connect drain hose to waste tee or waste disposer using one of
the following methods:
|.
Disconnect power.
.
.
.
.
mH
Option 1, Waste disposer — with air gap
2.
Turn off water supply.
Option 2, No waste disposer — with air gap
a
Pre
m
Option 3, Waste disposer — no air gap*
gb ae
a
Option 4, No waste disposer — no air gap*
*An air gap is recommended.
Helpful Tip: To reduce the vibration of the hose, keep the hose
dishwasher in an existing cabinet opening with utility hookups.
away from the floor and the edge of the hole where it passes
mg
If you are installing the dishwasher in a cabinet opening that
through the cabinet.
does not have hookups, follow the steps under "Prepare cabinet
opening where there are no existing utility hookups" section.
Option 1 , Waste disposer - with air gap:
'
:
].
Remove the disposer knockout plug. Cut end of drain hose if
needed (do not cut ribbed section).
|.
Check that the water
line reaches to the front
left of opening where
the water connection
will be made.
2.
Attach drain hose to air gap with large spring-type clamp. If
the drain hose was cut, use a 1/2" to 2" (3.8 to 5 cm) screw-type
clamp*.
2.
Check that the direct
-
3.
Use a rubber hose connector® with spring or screwtype clamps*
wire reaches to the
6" (15.2 ¢
front right of opening
where the electrical connection will be made.
to connect air gap to disposer inlet.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor where dishwasher will be installed.
If the water line and the direct wire reach far enough into the
opening, proceed to the next section "Install the drain hose." If they
do not reach far enough, follow the steps under "Prepare cabinet
opening where there are no existing utility hookups."
Drain hose -
cut here if needed
a
Rubber hose
connector
ey!
Spring of
screw-type
clamps
Large
spring-type
clamp
Drain
hose
Drain trap
4.
Insert drain hose through hole
Drain hose
cut in cabinet to the front
center of opening where
drain connection will be
made.
*Parts available from local
plumbing supply stores.
Advertisement
Chapters
Table of Contents
