Prepare Dishwasher - Kenmore Dishwasher Installation Instructions Manual

Option D, No waste disposer – with air gap
1. Connect rubber end of drain hose
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
2. Attach drain hose to air gap with
large drain hose clamp (provided).
Use pliers to squeeze clamp open
and move into position. If the drain
hose was cut, use a 1¹⁄₂" to 2" (3.8 to
5 cm) screw-type clamp (not
provided).
3. Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from waste
tee to air gap.

Prepare Dishwasher

WARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Remove and discard the foam blocks located above the front
legs on each side of the dishwasher. The blocks cover the rope/
link pulleys on the dishwasher.
11