Installation Instructions; Prepare Cabinet Opening- New Utilities; Install Optional Moisture Barrier - Recommended For Wood Countertops - Kenmore 66514165L120 Owner's Manual

Table of Contents

Advertisement

INSTALLATION INSTRUCTIONS

WARNING
Electrical Shock Hazard
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
Failure to do so can result in death or electrical shock.
1.
Video Installation
Video of installation steps can be found online at whirlpool.
com in the "Service & Support" section "How To's & FAQ.
The video can be found at
http://www.kaltura.com/tiny/ro00v
2.
Disconnect power
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
3.
Shut off water supply
Shut off the water supply to the dishwasher.
PREPARE CABINET OPENING—
NEW UTILITIES
4.
Drill hole locations—new construction
Optional
location
1½"
(3.8 cm)
The power-supply receptacle for the appliance shall be installed
in a cabinet or on a wall adjacent to the undercounter space in
which the appliance is to be installed.
NOTE: Refer to the "Product and Cabinet Opening Dimensions"
section for the correct hole placement and dimensions of the
shaded area.
Drill a 1½" (3.8 cm) drain hose hole in the side or rear of cabinet,
depending on location of drain hose routing and drain hose
connection location.
Drill a 1/2" (1.27 cm) water supply hose hole in the side or rear
of cabinet, depending on location of water supply routing and
connection location
Drill a 1½" (3.8 cm) electrical conduit hole in the right-hand side
or rear of cabinet.
1.
Wood
Cabinet
Wood cabinet: Sand the hole until smooth.
Metal cabinet: Cover edges of hole with grommet included with
power cord kit.
Helpful Tip: Wiring the dishwasher will be easier if you route
the cable into the cabinet opening from the right-hand side.
INSTALL OPTIONAL MOISTURE BARRIER -
RECOMMENDED FOR WOOD COUNTERTOPS
Moisture barrier/wood shims
Preferred
location
1/2"
(1.27 cm)
Make sure the area under the cabinet is clean and dry for
installation of the moisture barrier. Remove the backing of the
moisture barrier, and apply to underside of the countertop along
the front edge of the counter.
NOTE: The use of this moisture barrier is recommended but not
required.
NOTE: Install wood shims if side anchoring and the gap between
the sides of the cabinet and sides of the dishwasher are greater
than 1/2" (1.27 cm) on each side or are greater than the length of
the side anchor screws.
Sand holes smooth
Moisture
barrier
Install
wood
shims
Metal
Cabinet
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

66514169l120

Table of Contents