List 93 Battery Tray; Installing The Rectifier And Dc-Dc Converter Modules - Vertiv NetSure 710 Series Quick Start Manual

Hide thumbs Also See for NetSure 710 Series:
Table of Contents

Advertisement

5.8 List 93 Battery Tray

Refer to Installing and Connecting Batteries in a List 93 Battery Tray (if furnished) in the MAKING ELECTRICAL CONNECTIONS
section of the Installation Instructions (IM581127000) for a complete procedure.
6 Installing the Rectifier and
DC-DC Converter Modules
The module location diagram on the front of each shelf shows which type modules can be operated in that shelf. (See Figure 6.1.)
Rectifiers will operate in any mounting position in any shelf. If a shelf accepts DC-DC converter modules, they must be installed in any
or all of the four middle mounting positions.
Procedure
1.
Unpack the modules.
2.
Note the model number located on the handle of each module. Model numbers starting with the letter "R" (R24-2500 or 24-
3000) are rectifiers. Model numbers starting with the letter "C" (C24/48-1500) are DC-DC converter modules.
3.
Check the module location diagram on the front of the shelf to determine which type of module (rectifier or DC-DC
converter) can be installed in each mounting position. See Figure 6.1.
4.
If present, remove blank cover panels from the mounting positions into which rectifier or DC-DC converter modules are to be
installed.
5.
Place the module into an unoccupied mounting slot without sliding it in completely.
6.
Loosen the captive screw on the module handle. Pull the handle to pivot it out of the module front panel (this will also retract
the latch mechanism located at the right side of the module). See Figure 6.2.
7.
Push the module completely into the shelf.
8.
Push the handle into the front panel of the module. This will lock the module securely to the shelf. Tighten the captive screw
on the handle.
9.
Repeat the above steps for each module being installed in the system.
10.
After the modules are physically installed in the mounting shelf(s), they are ready for operation immediately after power is
supplied to them.
Proprietary and Confidential © 2023 Vertiv Group Corp.
Vertiv™ NetSure™ 710 Series +24 VDC Power System Quick Start Guide
57

Advertisement

Table of Contents
loading

Table of Contents