Removing Fan Motors; Removing The Start Relay And Overload Protector - Vinotemp WINE-MATE VINO3500HZD Service Manual

2. Remove the WINEMATE cooling unit from the enclosure opening.
3. Remove the outer cover.
4. Remove the top large styrofoam cover.
5. Disconnect the thermistor with connector from the digital controller.
6. Remove the thermistor from the mounting clip on the front of the
evaporator.
6) Removing the Fans
The 2 condenser and evaporator fans are attached to the horizontal fan plate.
They are the same and all powered up at the same time.
1. Unplug the WINEMATE cooling unit or disconnect power.
2. Remove the WINEMATE cooling unit from the enclosure opening.
3. Remove the outer cover.
4. Remove the top large styrofoam cover.
5. Disconnect the two wires going to the electrical junction block.
6. Remove the four screws holding the fan to the plate.

8) Removing the Start Relay and Overload Protector

Figure 2-9
Figure 2-10
- 10 -