RDZ CHR 400 CoRe Installation & Technical Manual page 27

Air handling units, mechanical ventilation with heat recovery appliance
Table of Contents

Advertisement

RENEWAL (V2)
The system is designed to provide measured amounts of filtered,
fresh air to living areas while constantly removing polluted, stale
air from bathing, cooking and washing areas at the same gentle
rate. Any available heat in the outgoing stale air is recovered by a
built-in heat exchanger and used to pre-warm the fresh supply air.
The air filters in the appliance ensure that the fresh supply air
is clean as it enters the home. Additionally, the stale extract
air is filtered to protect the heat exchanger from unwanted
contamination.
BOOST (V3)
Boost function, enabled through the usser interface or a manual
switch, makes it possible to increase the ventilation flow rate when
cooking or showering thereby maintaining a comfortable indoor
environment.
AWAY (V1)
Activating "Away" via the user interface or a switch it is possible
to reduce the ventilation flow rate (value that can be set for both
seasons) at a lower speed than the Renewal one.
FROST PROTECTION
The unit is equipped with an antifreeze protection system.
During periods when the outside temperatures are particularly
harsh, the Supply Air fan automatically reduces its speed in order
to limit the load on your heating system and prevent the exchanger
from freezing.
Ventilation may temporarily stop if the expulsion temperature
drops below 2°C
RINNOVO (V2)
Il sistema è progettato per fornire un valore misurato di
aria pulita e filtrata nelle stanze abitate mentre rimuove
continuamente l'aria esausta e sporca da bagni,cucina e aree
di lavaggio alla stessa portata. Tutto il calore espulso viene
recuperato da uno scambiatore interno e viene utilizzato per
pre-riscaldare l'aria in ingresso.
I filtri aria dell'apparecchiatura garantiscono aria pulita in
ingresso all'abitazione. Inoltre l'aria di espulsione è filtrata
per proteggere lo scambiatore di calore da contaminazioni
estranee.
BOOST (V3)
Attivando il Boost tramite interfaccia utente o un interruttore
è possibile incrementare la portata di ventilazione quando si
cucina o ci si sta facendo una doccia in modo da mantenere un
ambiente confortevole.
AWAY (V1)
Attivando "Away" tramite interfaccia utente o un interruttore è
possibile ridurre in valore percentuale la portata di ventilazione
(valore impostabile per entrambe le stagioni) ad una velocità
inferiore rispetto a quella di Rinnovo.
PROTEZIONE ANTIGELO
L'unità è dotata di un sistema di protezione antigelo. Durante
i periodi in cui le temperature esterne sono particolarmente
rigide, il ventilatore di Immissione aria riduce automaticamente
la sua velocità al fine di limitare il carico sul proprio sistema di
riscaldamento ed evitare che lo scambiatore possa ghiacciarsi.
La ventilazione potrebbe interrompersi temporaneamente
qualora la temperatura di espulsione dovesse scendere sotto
i 2°C
27

Advertisement

Table of Contents
loading

Table of Contents