Unpacking And Examining Your Oven; Choosing A Location For Your Oven - Viking Professional VHSO205 Use And Care Manual

unpackinG anD eXamininG
your oven
Remove all packing materials from inside the oven cavity; however, DO NOT
REMOVE THE WAVEGUIDE COVER, which is located on the right cavity wall.
Read enclosures and SAVE the Use
and Care Guide.
Remove the feature sticker from the
outside of the door, if there is one.
Check the oven for any damage, such
as misaligned or bent door, damaged
door seals and sealing surfaces,
broken or loose door hinges and
latches and dents inside the cavity or
on the door. If there is any damage,
do not operate the oven and contact
your dealer or VIKING AUTHORIZED
SERVICER.
cHooSinG a location for
your oven
You will use your oven frequently,
so plan its location for ease of
use. The oven must be placed on
a countertop which is a minimum
of 36" from the floor. Allow at
least 2" on the sides, top and at
the rear of the oven for air circula-
tion. Be sure to position oven so
that the rear cannot be touched
inadvertently.
Your oven can be built into a
cabinet or wall by itself or above
any electric wall oven.
note for built-in trim kits:
See sketch 1 for proper location when building in above the specified wall
oven. Carefully follow the wall oven installation instructions. Be sure that
the clearance of the floor between the wall oven and the high speed oven
is minimum of 3".
Safety door latches
Door seals and
sealing surfaces
Min.
3"
Min.
36"
Sketch 1

Waveguide cover
Door hinges
Electric Wall Oven