Specifications - Vitek VT-2233 Manual Instruction

If the hairdryer is switched off during operation,
switch it off with the switch (5) by setting it to the
position «0», unplug the hairdryer from the mains
socket, make sure that the air inlets and outlets
are unblocked and let the hairdryer cool down for
5-10 minutes. After that you can switch it on again.
Do not block the air inlets during unit operation
and avoid getting of hair into its air inlet.
CLEANING AND MAINTENANCE
This hair dryer is intended for household usage only.
• Set the switch (5) to the position «0» and dis-
connect the unit from the mains.
• Turn the air inlet grid (3) counterclockwise and
remove it. Clean the grid (3) off possible hair
and dust. Install the grid (3) on the hairdryer
body (2) and turn it clockwise as far as it will go.
• You can clean the hairdryer body (2) with a wet
cloth. Then it is necessary to wipe it dry.
•
You can wash the nozzle (1) with warm water
and dry it before installing on the hairdryer.
•
Do not use solvents or abrasives for cleaning
of the hairdryer.
STORAGE
•
Always unplug the hairdryer if it is not being
used.
• Never wind the cord around the hairdryer,
as this can damage the cord. Do not pull,
twist or stretch the cord especially near the
power cord plug or at junction point to the unit
body. Periodically straighten the cord if it gets
twisted.
• Keep the hairdryer in a dry cool place out of
reach of children and disabled persons.
DELIVERY SET
Hair dryer – 1 pc.
Concentrating nozzle – 1 pc.
Warranty certificate – 1 pc.
Operating manual – 1 pc.

SPECIFICATIONS

Power supply: 220-240 V ~ 50-60 Hz
Rated input power: 1200-1400 W
ATTENTION! Do not use the unit near water in the
bathrooms, showers, swimming pools etc.
RECYCLING
For environment protection do not throw out the
unit and the batteries (if included), do not discard
the unit and the batteries with usual household
waste after the service life expiration; apply to spe-
cialized centers for further recycling.
The waste generated during the disposal of the
unit is subject to mandatory collection and conse-
quent disposal in the prescribed manner.
For further information about recycling of this
product apply to a local municipal administration,
a disposal service or to the shop where you pur-
chased this product.
The manufacturer preserves the right to change
design, structure and specifications not affecting
general principles of the unit operation without a
preliminary notification due to which insignificant
differences between the manual and product may
be observed. If the user reveals such differences,
please report them via e-mail info@vitek.ru for
receipt of an updated manual.
Service life of the unit – 3 years
Guarantee
Details regarding guarantee conditions can be ob-
tained from the dealer from whom the appliance
was purchased. The bill of sale or receipt must be
produced when making any claim under the terms
of this guarantee.
This product conforms to the EMC
Directive 2014/30/EU and to the Low
Voltage Directive 2014/35/EU.
9
ENGLISH