Table of Contents
Advertisement
Available languages
Available languages
If the device is installed in vehicles for commercial use, the national legal
and insurance requirements need to be considered by the operator.
The device is not intended for use in altitudes above 2000 m.
This product is only suitable for the intended purpose and application in
accordance with these instructions.
This manual provides information that is necessary for proper installation
and/or operation of the product. Poor installation and/or improper oper-
ating or maintenance will result in unsatisfactory performance and a possi-
ble failure.
The manufacturer accepts no liability for any injury or damage to the prod-
uct resulting from:
•
Incorrect installation, assembly or connection, including excess volt-
age
•
Incorrect maintenance or use of spare parts other than original spare
parts provided by the manufacturer
•
Alterations to the product without express permission from the manu-
facturer
•
Use for purposes other than those described in this manual
Dometic reserves the right to change product appearance and product
specifications.
The manufacturer accepts no liability for any injury or damage to the prod-
uct due to frost caused by the user not following the instructions in the
manual.
Data plate
A data plate is attached to the device. This data plate provides the user
and fitter with information on specifications of the device.
Installation
!
CAUTION! Risk of injury
The device must only be installed by qualified personnel
from a specialist company. The following information is
intended for technicians who are familiar with the guidelines
and safety precautions to be applied.
Notes on installation
Read this installation manual completely before installing the device.
The following tips and instructions must be observed while installing the
device:
!
WARNING! Electrocution hazard
Disconnect all power supplies when working on the device.
!
WARNING! Risk of injury
Close off the gas supply while the device is being installed
and connected to the gas supply.
!
CAUTION! Risk of injury
•
Improper installation of the device can result in irrepara-
ble damage to the device and put the safety of the user
at risk.
•
Always wear suitable protective clothing
(e.g. protective goggles, gloves).
A
NOTICE! Damage hazard
Observe the structural engineering of the vehicle and seal of
all openings made when installing the device.
10
Regulations
•
If the device is operated while driving, a safety shut-off device must be
installed to prevent an uncontrolled escape of LPG in the event of an
accident (according to UN ECE regulation 122).
If no safety shut-off device is installed, you can connect the D+ signal
to the device to prevent any operation while driving.
•
The installation of the device in vehicles must comply with the techni-
cal and administrative regulations of the respective country of use
(e.g. EN 1949).
The national legislation and regulations (e.g. DVGW Work Sheet G
607 for vehicles in Germany) must be observed.
Notes on transport
See fig. 3, page 3.
Notes on installation location
!
WARNING! Risk of suffocation
The cowl must be positioned in such a way that exhaust
gases cannot enter the interior.
•
Never run the exhaust duct outwards on the underside
of the vehicle. Always run the exhaust duct to the side
using a side cowl.
Observe the notes given in fig. 4, page 3 to fig. 6,
•
page 3.
!
WARNING! Electrocution hazard
The device must be built in where it is protected from water.
•
Never install the device directly under or in close prox-
imity to a sink.
•
Do not touch the device if it got into contact with water.
Observe the notes given in fig. 4, page 3 to fig. c, page 4.
•
•
Choose a place that is easily accessible for servicing as well as install-
ing and disassembling.
•
Do not place the device on or above heat-sensitive materials.
•
Do not place the device directly underneath a power supply socket.
•
Before installing the device, check whether any vehicle components
could be damaged by the installation of the device (such as lamps,
cupboards, doors).
•
For safety reasons, note the location of existing wiring harnesses,
wires and other components within the installation area, in particular
those which are not visible, when installing the device (when drilling
or screwing etc.).
•
If the cowl is installed under a window that can be opened, an electric
window switch must be installed.
•
Make sure that the air drawn in by the device cannot be contaminated
by vehicle exhaust gases or by exhaust gases from the device.
•
The safety and drain valve must be installed directly besides to the
device. It must be placed below the cold water connection. It must be
easily accessible for operation.
Notes on connection to the water supply
!
WARNING! Health hazard
•
Only connect the device to a portable water supply.
•
Never connect the device to water that is not drinking
water.
•
Only install the device in a water cycle which contains a pressure
pump with pressure regulator.
4445103144
EN
Advertisement
Table of Contents
