Epilog Laser Fusion Maker Manual page 3

17000 - Y-Axis Home Switch Replacement
Y-Axis Home Switch Installation
1. Connect the two (2) electrical
connections on the y-axis home switch:
2. Position the y-axis home sensor over
the mounting holes on the chassis of
the engraver. Install and tighten the two
(2) Phillips screws that secure it to the
chassis of the engraver:
3. Replace the side panel of the engraver.
If further assistance is required, please
contact Epilog Laser Technical Support by
phone at 303-215-9171, or by email at
tech@epiloglaser.com.
3