Calibration Procedure - Epilog Laser Fusion Maker Manual

17000 - Touchscreen Calibration
4. The engraver will prompt the user to
press a target in each corner of the
display.
5. Press the target in the upper-left hand
corner:
6. Press the target in the upper right
hand corner:
7. Press the target in the lower left hand
corner:
8. Press the target in the lower right hand
corner:
9. Once the last target is pressed,
the engraver will return to the
Advanced Settings menu. There is no
success message for this calibration
procedure.
If further assistance is required, contact
Epilog Laser Technical Support by phone
at 303-215-9171, or by email at
tech@epiloglaser.com.
3