Table of Contents
Advertisement
Figure 22:Webpage for configuring the Wi-Fi parameters
The URL for connecting the Web-HMI can also be changed from this page. But once
changed, the utility or the user needs to remember the new URL to connect to the Web-
HMI.
To prevent Wi-Fi access attempts by unauthorized persons, an option to automatically turn
off the Wi-FI is provided. If the setting Wi- Fi Auto Off is enabled, then if the device detects
no activity over the Wi-Fi communication for about 20 mins, then device Wi-FI is turned
off automatically.
Once turned off, the Wi-Fi can be enabled by toggling the NRM handle or by using a light
source like a torch with a strong non divergent beam. The steps for the same can be seen
from the instruction manual of EAGLE.
7.2 Station mode Configuration
In station mode EAGLE connects with CIM605 Gateway, with the help of gateway the data
of eagle and relevant information will be send to remote control center.
The users with "Admin" credentials can configure the device in Station mode and related
parameters as per requirement.
SSID name is the name of the Wi-Fi network of CIM605 Gateway device. The default SSID
name is CIM605_Eagle.
"Own Eagle IP address" is read only parameter to show the IP address of the Eagle ( IP
address corresponding to Mac address configured in CIM605 Gateway router
configuration page)
Other two Eagle IP address is automatically assigned based on own eagle IP Address
If RER605 own IP address is assigned as 192.168.1.1 then other two eagle will
automatically assign to 192.168.1.2 &192.168.1.3
39
Advertisement
Table of Contents
