Table of Contents
Advertisement
Inputs/Outputs
3. Select Expansion Modules > Option I/O Modules, and then select the desired I/O option
module tab.
4. If there are no I/O option modules connected, no information other than column headers is
displayed.
To view option module data using meter webpages:
1. Connect to your meter webpages.
2. Go to Monitoring > Inputs/Outputs, and then select Digital Inputs, Digital Outputs,
Analog Inputs or Analog Outputs.
3. If there are no I/O option modules of the specified type, no entries other than column
headers are displayed.
To view option module data using the display:
Go to Inputs/Outputs, and then select Digital Inputs, Digital Outputs, Analog Inputs or
Analog Outputs.
I/O option module configuration
You can configure your meter's I/O option modules using ION Setup.
The Option I/O Modules screen has tabs corresponding to the possible option modules, which are
identified based on how the option modules are connected to the meter. Each tab indicates the
module's type and status and has an area where the module's ports are listed for viewing and
configuration. You can also reset your meter's option modules using ION Setup.
Status examples
None
Normal
Option module added
Option module removed
Invalid S19
Invalid card
Analog inputs
Analog input applications
You can use an analog input to monitor an analog signal, for example a flowmeter, to monitor how
much water flows through a pipe.
For analog input operation, your meter takes an analog input signal and provides the resulting
scaled value.
Your meter's analog I/O option modules can measure either low voltage or current using standard
analog transducers such as 4–20 mA current transducers.
131
Description
No option module detected
The option module is operating normally
A new option module is detected
The option module has been removed
The option module's firmware is not supported
The option module type is not supported
9810 series - User manual
7EN05-0390-08
Advertisement
Table of Contents
Troubleshooting
