Configuring Custom Modbus Data Using Ion Setup - Siemens US2:9810T24V User Manual

Communications
Data Mapping module
Data Mapping Egy
Data Mapping EN
Data Mapping EN Prev
Data Mapping IEEE519
Data Mapping I/O
Data Mapping Meas
Data Mapping PQ
Data Mapping Stats
Data Mapping TOU
You can add extra Modbus information or duplicate information that is already in the fixed map to
different Modbus registers using Modbus Slave modules.
For more information on Data Mapping modules and Modbus Slave modules, see ION Reference,
available on www.usa.siemens.com/pds.

Configuring custom Modbus data using ION Setup

You can add custom data to your meter's default Modbus map, completely customize your
meter's Modbus map, or revert your meter's Modbus map back to its default configuration using
ION Setup.
Download your meter's Modbus map information from www.usa.siemens.com/pds.
To configure custom data using ION Setup:
1. Start ION Setup.
2. Open the Setup Assistant for your meter.
107
Description
Maps kWh, kVAh, and kVARh delivered, and received
data, including conditional, quadrant, and incremental
energies.
Maps present interval EN 50160 power quality
compliance data.
Maps previous interval EN 50160 power quality
compliance data.
Maps IEEE 519 harmonics compliance data.
Maps input metering data, alarms, resets, and reset
counts.
Maps voltage, current, power, power factor, and
frequency data for one second and half-cycle
measurements.
The Cfg Modbus Map Enable setup register may exist in
this module.
Maps power quality data such as Crest Factor, K Factor,
and total harmonic distortion, including IEC 61000-4-30
power quality compliance data.
Maps statistical low, mean, and high data values, such
as I a mean (phase A current average value).
Maps time-of-use (TOU) data, such as seasons, rates,
and per-season demand, such as kW sd rec A (sliding
demand kilowatts received in season A).
9810 series - User manual
7EN05-0390-08