Table of Contents
Advertisement
2 PIN PLUG-PROGRAM/OVERRIDE SWITCH:
This switch is used for programming features, transmitters, and valet mode.
2 PIN PLUG-(OPTIONAL) LED:
The LED is used as an indicator for Valet, Programming, and for use as security deterrent with the optional ANTI-
GRIND/STARTER DISABLE feature installed. Mount in a visible location on the dash or in the console if desired.
PIN 1 & 2: YELLOW / YELLOW/WHITE: (-) IGN / (-) ACC OUTPUTS (FOR ADDING RELAYS)
Use these wires when the vehicle requires a second IGNITION or ACCESSORY circuit to be activated. This occurs on
Toyota, late GM, and other models of vehicles. This wire is also used to activate ANTI-THEFT or TRANSPONDER
Bypass Modules. Connect to the "ground when running" input of the bypass module. (See Diagram Below.)
YELLOW or
YELLOW/WHITE
Diode isolate
if using both!
PIN 3: BLACK: MAIN SYSTEM GROUND
Connect to chassis metal of the vehicle. An existing bolt or screw MAY provide an adequate ground, or drill a small
hole, scrape away paint and attach using a sheet metal screw & star washer. This wire MUST be connected to a good
ground or undesirable and inconsistent operation will occur.
WIRING
OR
2nd IGN/ACC
(If needed)
OR
85
86
30
87
3
ANTI-THEFT/
TRANSPONDER
MODULE
+12V CONSTANT
IGN SW.
Advertisement
Table of Contents
