Transmitter Programming; Vehicle Operation - CrimeStopper Cool Start RS-850 Instalation Instructions

Remote engine starting system

Hide thumbs Also See for Cool Start RS-850:

Table of Contents

Note: All transmitter codes must be learned at time of programming!! The RS800 allows storage of up to 4

different transmitter codes.

1. Open Hood. (Ground Gray wire.)

2. Turn key to the ON position.

3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.

4. Press button #1 of the transmitter to be coded. You should get 2 light flashes indication the unit is waiting for a 2

code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting for the 3

lights will flash 4 times for 4

otherwise turn key OFF and close hood.

The RS-850 system can be used for 2 car operation. A single RS-850 remote can

control two independent vehicles with RS-850 systems installed.

SETUP:

1. Using the switch on the side of the remote set your controller to Car II.

2. At Car II: Simply follow the transmitter programming steps listed in the

section above. Learn YOUR remote, along with Car 2's existing remotes.

TRANSMITTER PROGRAMMING

code. If all 4 codes are learned, the unit will automatically exit code learning mode,

CAR I / CAR II OPERATION

CAR I

START

Slide

CAR II

code and

Table of Contents