Starting The Continuous Programme - Miele PLW 8615 Safety Operating Instructions Manual

System settings
Starting the con-
tinuous pro-
gramme
60
A repeated programme start can be defined for a reprocessing pro-
Iterative programme
gramme in the
for wash-related trials, e.g. material tests, or for periodic decontamin-
ation in the event of long downtimes.
Press the Iterative programme

The display shows the available load carriers.
Press the button for the required load carrier.

The available reprocessing programmes are displayed.
Press the button for the required reprocessing programme.

The parameters for defining the continuous programme are displayed.
The buttons next to the parameters open the on-screen keyboard.
The limits for the selected parameters are displayed in the header of
the on-screen keyboard.
Parameters for the continuous programme
Parameter Definition
Programme Number of programme cycles for the continuous
cycles programme
Pause between Period between the end of the programme and the
programme subsequent programme start
cycles
Door delay Period between the end of the programme and the
opening of the machine door
Open door for Period between the opening and closing of the
machine door
Door selection Choice of machine door which is opened after a
programme run
Enter the required values for each parameter.

Press the  button in the footer to start the continuous pro-

gramme.
The message Iterative programme: Warning! Door opens and closes
automatically.
will appear on the display. Press OK to start the con-
tinuous programme and  to cancel the procedure.
Once it has been started, the reprocessing programme is repeated
until the set programme runs are reached.
You can cancel the continuous programme at any time with the 
button.
menu. This function can be used
button.