Built-In Printer (Optional); Replacing The Paper Roll - Miele PLW 8615 Safety Operating Instructions Manual

Replacing the pa-
per roll

Built-in printer (optional)

a
Lever for opening the flap
b
LED
c
Paper feed
d
Acknowledgement button
LED status
Off
On
Flashing x1
Flashing x2
Flashing x3
Flashing x4
The paper roll for the built-in printer may not be replaced while a
programme is running.
When the LED  flashes three times, this indicates that the paper roll
has run out. To replace the paper roll, proceed as follows:
Pull the lever  on the printer flap and lift the flap upwards.

Take the empty paper roll out of the printer compartment and insert

the new paper roll.
The end of the paper roll is on the bottom side of the compartment.
Pull a bit of the end of the paper out of the compartment and close

the printer flap.
Cut off the protruding strip of paper.

Press the acknowledgement button .

The printing process will continue.
Printer status
Power supply fault
Ready for operation
Not ready for operation
Fault on the printer head
Paper jam/paper roll empty
Temperature fault
Maintenance
77