Table of Contents
Advertisement
H Type Designation Label and Code Key
Supply:
ACS141 = 1 ~
ACS143 = 3 ~
ACS141-xxx-1 = 200 V
ACS141-xxx-3 = 400 V
Power:
1K6 = 1.6 kVA standard
series (frames A, B, C
and D)
1H6 = 1.6 kVA
heatsinkless series
(frame H)
I Floating Network
If the supply network is floating (IT network) remove the grounding
screw (GND). Failure to do so may cause danger or damage the unit.
In floating networks do not use RFI filter. The mains becomes connected to
earth through the filter capacitors. In floating networks this may cause
danger or damage the unit.
Make sure that no excessive emission is propagated to neighbouring low
voltage networks. In some cases, the natural suppression in transformers
and cables is sufficient. If in doubt, a supply transformer with static screening
between the primary and secondary windings can be used
J Motor
Check that the motor is compatible. The motor must be a three-phase
induction motor, with U
either 50 Hz or 60 Hz. If the motor values differ from these, the group 99
parameter values must be changed.
The motor nominal current, I
of the ACS140, I
ABB
ABB Oy
ACS143-1K6-1
U1 3*200...240V U2 3*0..U1
f1 50/60 Hz
I1 5.3 A
S/N 242A0001
from 200 to 240 V or from 380 to 480 V and f
N
, must be less than the nominal output current
N
(See H and R).
2
ac.maher.co.ir
f2 0..300 Hz
I2 4.3 A
GND
Serial number:
S/N 242A0001
2= Year 2002
42 = Week 42
A0001=Internal
number
N
Advertisement
Table of Contents
