Application Macro Factory (1) - ABB ACS140 User Manual

Application Macro Factory (1)

This macro is intended for applications where there is no control panel
available. It provides a general purpose 3-wire I/O configuration.
The value of parameter 9902 is 0. DI 4 is connected.
Input signals
• Start, stop and direction (DI1,2,3) • An. output AO: Frequency
• Analogue reference (AI1)
• Ramp pair 1/2 selection (DI5)
mA
*Note! DI 4 is used to configure ACS140. It is read only once when power is
connected. All parameters marked with * are determined by the DI4 input.
Note! Stop input (
(local).
Factory (1) parameter values:
*1001 1
EXT COMMANDS
1002 2
EXT COMMANDS
1003
DIRECTION
1102 1/ 2
EXT EXT SEL
1103 1
EXT REF SELECT
Output signals
• Relay output 1: Fault
• Relay output 2: Running
Control
Function
Terminals
1 SCR
2 AI 1 External reference1; 0...10 V <=> 0...50 Hz
3 AGND
4 10 V Reference voltage 10 VDC
5 AI 2 Not used
6 AGND
7 AO Output frequency 0...20 mA <=> 0...50 Hz
8 AGND
9 +12 V +12 VDC
10 DCOM
11 DI 1 Momentary activation with DI2 activated: Start
12 DI 2 Momentary deactivation: Stop
13 DI 3 Fwd/Rev; Activate to reverse rotation direction
14 DI 4 Has to be connected!*
15 DI 5 Ramp pair selection. Activate to select ramp pair 2.
Defaults: 5 s (ramp pair 1), 60 s (ramp pair 2)
16 RO 1A
17 RO 1B
18 RO 2A
19 RO 2B
2) deactivated: panel START/STOP button interlocked
DI
4 ( 1 ,2 ,
DI P P P
0 ( )
NOT SEL
3 (
REQUEST
6 ( 1)
EXT
1 ( 1)
AI
ac.maher.co.ir
) 1106 2
EXT REF
*1201
CONST SPEED SEL
) 1601
RUN ENABLE
2105
PREMAGN SEL
2201 / 1/2
ACC DEC
DIP switch S1
S1:1:U
Relay output 1
Fault: open
Relay output 2
Running: closed
0 (
SELECT KEYPAD
0 (
NOT SEL
0 (
NOT SEL
0 (
NOT SEL
5 ( 5)
SEL DI
)
)
)
)