Understanding The System Status Leds; How To Connect To The Console Port; Figure 24: System Leds; Table 10: System Status Leds - Edge-Core ECS2100-10P Installation Manual

Understanding the System Status LEDs

How to Connect to the Console Port

The switch includes a display panel of key system LED indicators. The LEDs, which
are located on the front panel, are shown below and described in the following
table.

Figure 24: System LEDs

1 System Status LEDs.

Table 10: System Status LEDs

LED Condition
Power/PoE Max On Green
On Amber
Off
Diag Flashing Green
(Diagnostic)
(ECS2100-10T/ On Green
P/PE/28T/P/PP/
52T/ECS2110- Off
26T)
The RJ-45 Console port on the front panel of the switch is used to connect a
console device to the switch for out-of-band console configuration. The console
device can be a PC or workstation running a VT-100 terminal emulator, or a VT-100
terminal. A console cable is supplied with the switch for connecting to a PC's
RS-232 serial DB-9 DTE (COM) port.
Note: To connect to notebooks or other PCs that do not have a DB-9 COM port, use
a USB-to-male DB-9 adapter cable (not included with the switch).
Understanding the System Status LEDs
1
Status
Internal power operating normally.
The PoE device power draw on the switch has reached the
system limitation.
No AC power is connected or the internal power supply
has failed.
System diagnostic in progress.
The system diagnostic test has completed successfully
System boot up failed.
– 47 –
Chapter 6
| Switch Management