Table of Contents
Advertisement
Available languages
Available languages
HANDLE AND WHEELS ASSEMBLY (FIG. 2)
•
Unpack the welder.
•
Screw the two casters (D) to the machine.
•
Insert the axle (A) thru the holes at the rear of the welder and slide a wheel (B) on to each end followed
by the retaining washers (C).
•
Assemble the plastic handle (E) using the screws provided (F).
TORCHES' LEADS ASSEMBLY (FIG.3)
•
Follow the indications inside wire spool compartment to correctly define the correspondence betwe-
en torch and Euro connection.
•
Plug the torches leads into the Euro sockets on the unit's front and secure by hand screwing in the
threaded connection.
Figure 2
ASSEMBLY
GAS BOTTLE SUPPORT BRACKET (FIG.4) AND TORCHES
HOLDING BAR (FIG.5) ASSEMBLY
•
The gas bottle support bracket is designed to accept or the Ø
200 gas bottle or two Ø 160 gas bottles at the same time.
•
Fix the support bracket in the correct position according to the
gas bottle you are going to install.
•
Assemble the torches holding bar following the here below pic-
tures indications.
Figure 5
200
Figura 3
Figure 4
29
7
Advertisement
Table of Contents
