Mig/Mag Welding Setup - Pro Spot SP-5 Instruction Manual

MODE Key -
1
Press the Mode Key till the MIG/MAG Welding
Screen is viewed on the display.
Unit can be set for working in three different
modes:
Normal MIG
Synergic MIG
Pulsed MIG.
Follow carefully the following instructions paying
particular attention to the pictures.
Torch Selection
Press the trigger of the torch that you need to use
for welding. The display will view the number cor-
respondent to the selected torch. All parameters
that will be changed in the next steps will refer to
the selected torch only.
MIG/MAG Function Setup Key -
In MIG/MAG Mode press the Setup Key - 3 - to enter the parameters change screen. Use the Setup Key
- 3 - to run through the parameters and adjust their values by turning the Right regulation Knob - 5 -.
1
SYNERGY OFF - unit ready for NORMAL MIG/MAG welding, voltage and wire speed
are adjustable
SYNERGY ON - unit ready for Synergic Mode Welding
PULSED - unit ready for Pulsed Mode Welding
MODE: selection of the 2Stroke / 4Stroke / Spot Welding Mode
Spot Time - adjustable only when Spot Welding Mode is set: regulation of the maximum
duration of the Spot Welding Time (0-10 sec)
Slope: regulation of the time the wire needs from the striking speed to the welding
speed (0-1.50 sec)
BBT: regulation of the lenght of the wire protruding from the torch at the end of welding
(1-10)

MIG/MAG WELDING SETUP

-
Figure 18
3.2
3.2
5
1
7.3
-
Figure 19
2
3.2
5
6.2
4
37
15