Lockly ACCESS TOUCH PRO Installation Manual page 8

Step 3
Do not install the wired door sensor yet. You will install in Step 6.
About door sensors
Door sensors provide real-time door condition status, such as the
ability to verify if the door is securely closed. It also sends push
notifications to your phone whenever your door opens and enables
voice control with Amazon Alexa or Hey Google.
Lockly Access Touch Pro comes with a pre-wired door sensors consisting
of two parts:
Part (P) - Wired
Sensor
TIP: Lockly door sensors comes in Grey (PGA715) and Matte
Black (PGA716) that can be ordered through our customer
hotline: (669) 500-8835 or by email: help@Lockly.com.
Removal of Sensor (optional)
There may be circumstances where the sensor cannot be installed
because of molding/door limitations or is not aesthetically desirable.
The sensor wired to the lock is removable by carefully pulling its connector
from the circuit board. If removed, some features and functionality
will not be available, such as real-time condition status.
When installed on door, the distance between the
wired sensor and sensor magnet must be less than
3/4" in order for the sensor to work.If door frame is
higher than door, add included foam pads to level
parts (P) and (Q) with each other as much as possible.
PREPARING WIRED DOOR SENSOR
7
Part (Q) - Sensor
Magnet