Table of Contents
Advertisement
CONNECTING THE APPLIANCE TO
THE POWER MAINS
Important warnings
• The appliance may only be connected by an authorized skilled technician.
• Electric system protection should comply with all relevant regulations.
• The connection clips can be accessed when the connection clip covers are opened /
removed.
• Before connecting the appliance, make sure the voltage indicated on the rating plate is
consistent with the voltage in your home circuit.
• The rating plate with basic information is attached on the lower side of the hob.
• The electric circuit should also include an omnipolar switch that will separate the
appliance from the mains, if required, with at least 3 mm of distance between contacts.
Suitable devices include fuses, current protection switches, etc.
• The connection should be selected according to the installation possibilities with
regard to current and fuses.
• Given the protection from the risk of fi re, appliances of this type may be installed in
a worktop next to a piece of kitchen furniture that is taller than the appliance (when
installed); however, in this case, a kitchen furniture element must be installed on the
other side, adjacent to the appliance.
• The current conducting and isolated parts must be protected from any possibility of
direct contact.
WARNING!
• Before any intervention, disconnect the appliance from the power mains. Connect the
appliance in compliance with the electric connections diagram supplied; make sure the
relevant network voltage is observed! The ground wire (PE) should be connected to
the clip indicated by the earthing symbol.
• The mains cable should be fed through the fastening clip which protects it from being
accidentally pulled out.
• After connecting the appliance, turn on all cooking zones / heaters for approximately
three minutes to make sure they are operating correctly.
Connection diagram
18
'' The appliances are suitable for photovoltaic electrical
power under the condition that electrical voltage will
be 220VAC - 240VAC with semi tonic frequency 50Hz
in order the appliance to operate properly (alternative
a generator can be used with the same technical
characteristic).''
• Incorrect connection may destroy parts of the appliance,
making the warranty void.
• Before connecting the appliance, make sure the voltage
indicated on the rating plate is consistent with the
voltage in your home network. Connection voltage
(230 V through N) should be checked by a qualifi ed
technician using a corresponding measuring device!
Advertisement
Table of Contents
