Advertisement
Installation procedure
Connecting the appliance to the power mains
Important warnings
• The appliance may only be connected by an authorized skilled technician.
• Electric system protection should comply with all relevant regulations.
• The connection clips can be accessed when the connection clip covers are opened / removed.
• Before connecting the appliance, make sure the voltage indicated on the rating plate is
consistent with the voltage in your home circuit.
• The rating plate with basic information is attached on the lower side of the hob.
• The electric circuit should also include an omnipolar switch that will separate the appliance from
the mains, if required, with at least 3 mm of distance between contacts. Suitable devices include
fuses, current protection switches, etc.
• The connection should be selected according to the installation possibilities with regard to
current and fuses.
• Given the protection from the risk of fi re, appliances of this type may be installed in a worktop
next to a piece of kitchen furniture that is taller than the appliance (when installed); however,
in this case, a kitchen furniture element must be installed on the other side, adjacent to the
appliance.
• The current conducting and isolated parts must be protected from any possibility of direct
contact.
12
• The worktop should be installed completely horizontally.
• The cutoff surfaces should be appropriately protected.
• Attach the fastening elements (4) with the supplied screws (4)
to the front and rear wall of the cooking hob and the worktop
cutoff .
• Connect the cooking hob to the power mains and gas supply
(see instructions for connecting a cooking hob on a power
network and gas supply).
• For screwing down the fi xing clip it is not allowed to use
screws longer than 6,5 mm.
• Attach the supplied adhesive seal on the lower edge of the
cooking hob.
• Insert the cooking hob into he cutoff and press it heavily from
above towards the worktop.
Advertisement
