Connecting The Appliance To The Power Mains - Gorenje Glass-ceramic built-in coking hob Instructions For Use, Installation, And Connection

Connecting the appliance to the power mains

Important warnings
• The appliance may only be connected by an authorized skilled technician.
• Electric system protection should comply with all relevant regulations.
• The connection clips can be accessed when the connection clip covers are opened / removed.
• Before connecting the appliance, make sure the voltage indicated on the rating plate is consistent
with the voltage in your home circuit.
• The rating plate with basic information is attached on the lower side of the hob.
• The electric circuit should also include an omnipolar switch that will separate the appliance from
the mains, if required, with at least 3 mm of distance between contacts. Suitable devices include
fuses, current protection switches, etc.
• The connection should be selected according to the installation possibilities with regard to current
and fuses.
• Given the protection from the risk of fi re, appliances of this type may be installed in a worktop
next to a piece of kitchen furniture that is taller than the appliance (when installed); however, in
this case, a kitchen furniture not higher than the cooking hob must be installed on the other side,
adjacent to the appliance.
• The current conducting and isolated parts must be protected from any possibility of direct contact.
18
millimeters from the lower surface of the worktop. The space
between the partition wall and the hob must be empty; no
objects should be placed into that gap.
• On the furniture back wall there should be a cutout with width
of at least 175 mm along the entire width of the furniture
element.
• Only type EVP4..,EVP2.., ovens fi tted with a cooling fan may
be installed underneath this cooking hob.
Installation procedure
• The worktop should be installed completely horizontally.
• The cutoff surfaces should be appropriately protected.
• Attach the fastening elements (4x - SVK6...600 mm; 6x
- SVK7...750 mm; 6x - SVK8...850 mm) with the supplied
screws (4x - SVK6...600 mm; 6x - SVK7...750 mm; 6x
- SVK8...850 mm) to the left and right wall of the cooking hob
and the worktop cutoff.
• Connect the cooking hob to the power mains (see instructions
for connecting a cooking hob on a power network).
• Insert the cooking hob into he cutoff and press it heavily from
above against the worktop.
• For screwing down the fi xing clip it is not allowed to use
screws longer than 6,5 mm.