Burmester 088 Operation Manual page 19

Hide thumbs Also See for 088:
Table of Contents

Advertisement

O P E R A T I O N
M A N U A L
Furthermore you have the option to switch through all inputs, independent of the
names, with the buttons STATION+ and STATION-. With the STATION+ button in
ascending order (INPUT
1
 INPUT
descending order (INPUT
4
 INPUT
NOTICE:
To be able to use the STATION +/- keys on your remote control
for switching between the inputs you have to set the menu item RC INPUT
in the GLOBAL SETUP to YES.
PLAYBACK VOLUME
With the buttons VOLUME + and VOLUME - you are able to adjust the volume for
the MAIN output. The volume level is shown in the display. By shortly pressing the
VOLUME buttons you are able to change the volume in small steps.
DISPLAY BRIGHTNESS
With the DIM button you are able to adjust the brightness of the display in
These steps vary between "max. brightness" and "off".
If you choose the option "off" the display will only light up when you change
anything. This gives you a feedback about the changes you are applying.
When you are done with your changes, the display will go blank again after a couple
of seconds. If you enter the SETUP MENU while display is "off", it will automatically
go to "maximum brightness" for the time you are in the SETUP MENU.
PHASE REVERSAL
Longer Pressing the DIM button (approx.
presently activated input channel by
the PHASE LED (2) will light up.
OUTPUT AMPLIFICATION
The button MODE changes the amplification of the preamp. At high amplification
the HIGH/LOW-LED (5) will illuminate.
NOTICE:
After changing the output amplification, the unit always switches
to volume level
01
respectively to -
3 6 | 4 6
2
 etc...), with the STATION - button in
3
 etc...).
4
steps.
2
seconds) will reverse the phase of the
180
°. When the phase reversal is active,
79
dB.
VOLUME DISPLAY
By holding down the MODE key (for approx. two seconds), you can switch the
volume increments and display between the dB scale and the Burmester scale.
UP SAMPLING
If you have a D/A-converter module, and the module input is selected you are able
to change the sample rate between
kHz (AUDIO LED (3) lights up) and
192
(AUDIO LED (3) is off). You may do so by shortly pressing the AUDIO button.
INPUT D/A MODULE
If you have a D/A-converter module and the module input is selected, you have the
option to select between the USB and the RCA input. Longer pressing the AUDIO
button (approx.
2
seconds) will switch the inputs.
SETUP MENUS
Longer pressing the D-MENU button (approx.
GLOBAL MENU. Shortly pressing D-MENU again will close the menu.
Shortly pressing the D-MENU button will open the MAIN MENU.
Shortly pressing the D-MENU button again will close the menu
Shortly pressing the AUDIO button will open the PHONO MENU, if a Phono MM
or MC module is equipped and the module input is selected. Shortly pressing
the MENU button will close the menu.
Longer pressing the AUDIO button (approx.
if a Phono MC module is equipped and the module input is selected.
Shortly pressing the MENU button will close the menu.
Longer pressing the AUDIO button (approx.
MM MENU, if a Phono MM module is equipped and the module input is selected.
Shortly pressing the MENU button will close the menu.
0 8 8
P R E A M P
kHz
96
2
seconds) will open the
seconds) will open the MC MENU,
2
2
seconds) will open the
3 7 | 4 6

Advertisement

Table of Contents
loading

Table of Contents