Table of Contents
Advertisement
MN004863A01-AN
Chapter 7: Advanced Features
●
Press the Menu Select button below Optn and select Dlay to delay the request to upgrade or
Rej to reject the request to upgrade.
Result: One of the following scenarios occurs:
●
If you choose to accept, the display shows Programming Dont power off to indicate that the
upgrade is about to begin. The radio resets to install the upgrade. In the case of configuration data
upgrade, the process only takes a few seconds. In the case of firmware upgrade, the installation takes
several minutes.
NOTE: The radio cannot be used while the upgrade is being installed. Therefore, make sure to only
accept the upgrade at a convenient time when immediate radio use is not required.
●
If you choose to delay, a configuration data upgrade is installed automatically at the next power up.
However, in the case of a firmware upgrade, the radio prompts Upgrade? again at the next power up.
●
If you choose to reject, the display shows Upg Aborted. The radio continues to function with the current
configuration until it gets reprogrammed.
NOTE: If your radio has problems upgrading over-the-air, consult a qualified technician for details.
7.23
Voice Announcement
This feature enables the radio to audibly indicate the current feature mode, zone, or channel assigned to the
user.
The available voice announcement (VA) priority options are:
High
Voice announcement is enabled even when the radio is receiving calls.
Low
Voice announcement is disabled when the radio is receiving calls.
NOTE: If the Voice Announcement field is set to Enabled, after an interruption by a momentary tone
one of the following scenarios occurs:
●
If Suppress Replay field is Enabled, voice announcement replays.
●
If Suppress Replay field is Disabled, voice announcement turns off.
7.24
Site Selectable Alerts (ASTRO 25 Trunking)
A Site Selectable Alert (SSA) is an Intelligent Lighting indicator with audio alert. The alert is sent to radios at
sites to notify the users when special situations occur.
Your radio supports up to 250 site aliases. Only authorized radios are enabled to send SSA.
NOTE:
The alert alias, alert tone, and alert period are configured in the Customer Programming Software
(CPS). For more information, contact your system administrator.
The SSA alert volume is reduced when voice audio is received at the same time. It is important that the
SSA audio file is created with clear loud audio to ensure audio clarity at reduced levels.
96
Advertisement
Table of Contents
