Table of Contents
Advertisement
MN004863A01-AN
Chapter 7: Advanced Features
Parameter
Editing Keys
Tx NAC
Rx NAC
Rx Type
Perform one of the following:
●
Tx Type
Bandwidth
Protect
Tx Deviation
Power Level
Hot Keypad
Busy LED
Low Batt LED
MPL Enable
Scan List
Zone Name
The names must be configured in CPS.
Top Chan
Name
Top Zone
Name
Chan Name
NOTE:
To edit Tx PL, Rx PL, Tx DPL, and Rx DPL, the PL Setting must be set to Disabled.
If PL setting is set to ALL, Rx or Tx, there is no Edit selection available to change the codes for Tx
PL, Rx PL, Tx DPL, or Rx DPL.
If PL setting is set to Rx, you can only edit Tx PL and Tx DPL codes.
If PL setting is set to Tx, you can only edit Rx PL and Rx DPL codes.
112
or
to increment or decrement entry and to move cursor within parameter value.
or
to toggle between valid entries.
Value
ANALOG/
DIGITAL/
MIXED
ANALOG/
DIGITAL
25kHz/20kHz/
12.5kHz
ON/OFF
5.0 kHz/4.0
kHz/2.5 kHz
High/Low
ON/OFF
ON/OFF
ON/OFF
Disabled/Rx/T
x/All
None/Scan
List 1, 2, 3,...
Advertisement
Table of Contents
