Table of Contents
Advertisement
MN004863A01-AN
Chapter 7: Advanced Features
If the channel deleted is the Home channel, the Home screen shows <Zone Name>"Blank".
7.1.7
Zone-to-Zone Cloning
Zone Cloning clones conventional zones from one radio to another.
You can select the followings zones from a source radio and clone them into a target radio.
●
Clone enabled zones
●
Dynamic Zones
●
Multiple Private Line (MPL)
You can clone the zones by connecting the source radio and target radio with a clone cable.
7.1.7.1
Cloning Zones
Procedure:
1. On the source radio, press the Menu Select button directly below Clon.
2. Press the Menu Select button directly below Sel to select source zone.
3. When connecting to the target radio, one of the following scenarios occurs:
●
If the radio is compatible, the radio displays Target radio connected. Proceed to
●
If the radio is not compatible, the radio displays Target radio incompatible. Press the
Menu Select button directly below Ok and the radio returns to the previous screen.
Once connected, the zone clone status is displayed on the right.
4. Press the Menu Select button directly below Next to accept the source zones selection. One of the
following scenarios occurs:
●
If you select a single source zone, press the Menu Select button directly below Sel to select the
target zones for cloning.
●
If you select multi-source zones, the radio displays Confirm target and shows the
automatically selected target zones and source zones mapping.
●
If the selected multi-source zones exceed the last clonable target zone, the radio displays
<#> src zones unselected, Sel exceed max tgt zone, and Protected tgts not
supported alternatively.
5. Press the Menu Select button directly below Clon to begin cloning.
Result: The radio displays Cloning...<Current cloning zone>. One of the following scenarios occurs:
●
If the cloning is successful, a tone sounds, the radio displays Clone successful and the source zone
alias is displayed on the right.
●
If the cloning is not successful, a tone sounds and the radio displays Clone failed. Press the Back
button to enter the source zone list.
●
If you press the Home button, the radio aborts cloning.
NOTE: The target radio enters programming mode during cloning and resets after cloning is completed.
48
step
4.
Advertisement
Table of Contents
