Attaching The Antenna; Removing And Attaching The Accessory Connector Cover; Attaching The Belt Clip - Motorola APX 1000i User Manual

2. To remove the battery, turn the radio off. Lift the latch at the bottom of the radio, then slide the battery
out from the radio.
NOTE: Radio supports revision B and above for PMNN4491 battery. Check with your dealer or
system administrator for more information.
2.3

Attaching the Antenna

Prerequisites: Ensure the radio is turned off before attaching the antenna.
Procedure:
1. Set the antenna in the receptacle.
2. Turn the antenna clockwise to attach to the radio.
3. To remove the antenna, turn the antenna counterclockwise.
NOTE: When removing the antenna, ensure that the radio is turned off.
2.4
Removing and Attaching the Accessory Connector
Cover
The accessory connector is on the antenna side of the radio. It is used to connect accessories to the radio.
NOTE: To prevent damage to the connector, shield it with the connector cover when not in use.
Procedure:
1. To remove the accessory connector cover, rotate the thumbscrew counterclockwise until it disengages
from the radio.
NOTE: If the thumbscrew is too tight, use an allen wrench to loosen it.
2. Rotate and lift the connector cover to disengage it from the radio.
3. To attach the accessory connector cover, insert the hooked end of the cover into the slot above the
connector.
4. Press the top of the cover downward to seat it in the slot.
5. Tighten by rotating the thumbscrew clockwise by hand.
2.5

Attaching the Belt Clip

Procedure:
1. Align the grooves of the belt clip with those of the radio and push down until you hear a click.
2. To remove the clip, use a flat-bladed object to press the belt clip tab away from the radio.
3. Slide the clip upward and away from the radio.
MN004863A01-AN
Chapter 2: Getting Started
17