Mitsubishi XPANDER HEV 2023 Manual page 43

Keyless operation system
Item
Key not detected Power switch is
pressed one time
3
Power switch is
pressed two times or
Keyless operation
key take-out monitor-
ing system
3-12 Locking and unlocking
Display Buzzer
Inner buzzer sounds
once
more
Inner buzzer sounds
once
Outer buzzer sounds
intermittently
Note (Solution)
When the operation mode of the power switch is put in ACC or ON from
OFF or when the Hybrid EV System is started, the warning is activated,
if any of the following conditions has occurred.
 Carrying another keyless operation key with a different code, or the
keyless operation key could be outside the operating range.
 The battery of the keyless operation key is dead.

Communication is blocked by electric wave environment.
In such case, touch the keyless operation key to the power switch to
change the operation mode of the power switch or start the Hybrid EV
System.
Refer to "If the keyless operation key is not operating properly" on page
6-17.
 When the vehicle is parked with the operation mode of the power
switch in any mode other than OFF, if you close the door after open-
ing any of the doors and taking the keyless operation key out of the
vehicle, a warning is issued until the key is detected in the vehicle.
 If you take the keyless operation key out of the vehicle through a win-
dow without opening a door, the keyless operation key take-out moni-
toring system does not operate.
 It is possible to change the setting to make the keyless operation key
take-out monitoring system operate if you take the keyless operation
key out from the vehicle through a window without opening a door.
For further information, please contact an authorised MITSUBISHI
MOTORS dealer.
 Even if you have the keyless operation key within the Hybrid EV Sys-
tem start operating range, if the keyless operation key and vehicle ID
codes cannot be matched, for example due to the ambient environ-
ment or electromagnetic conditions, the warning may be activated.