Mitsubishi XPANDER HEV 2023 Manual page 52

NOTE
 If the security indicator lamp in the instru-
ment cluster does not blink after the locking
operation using the keyless entry system or
the keyless operation function, the security
alarm system may be malfunctioning.
Have the vehicle inspected at an authorised
MITSUBISHI MOTORS dealer.
4. After approximately 20 seconds, the
buzzer stops, and when the blinking of the
security indicator lamp starts to slow
down, the system armed mode goes into
effect.
The security indicator lamp continues to
blink during the system armed mode.
NOTE
 The security alarm system can be activated
when people are riding inside the vehicle or
when the windows are open. To prevent acci-
dental activation of the alarm, do not set the
system to the system armed mode while peo-
ple are riding in the vehicle.
 Avoid leaving valuable items inside the vehi-
cle even when the security alarm system has
been set to the "active" mode.
Cancelling the system
The following methods can be used to cancel
the system when it is in the system prepara-
tion mode or the system armed mode.
 Pressing the UNLOCK switch on the key.
 Putting the operation mode of the power
switch in ON or ACC.
 Opening any one of the doors or the tail-
gate, when the system is in the system
preparation mode.
 Holding the keyless operation key and
pressing the driver's or front passenger's
door lock/unlock switch, or the tailgate
opener switch to unlock the doors and the
tailgate.
NOTE
 If the auxiliary battery terminals are discon-
nected while the system is in the system
preparation mode, the memory will be
erased.
 As long as the keys are registered, any of the
keys other than the one used to activate the
system, can be used to cancel the system.
If you want to register additional keys,
please contact an authorised MITSUBISHI
MOTORS dealer.
Security alarm system
NOTE
 The activation distance for keyless entry sys-
E00301802797
tem is approximately 4 m.
If it is not possible to lock or unlock the
vehicle by pressing the switch at the correct
distance or the security alarm system cannot
be set or cancelled using the switch, the bat-
tery may need to be replaced.
Replace the battery at your authorised
MITSUBISHI MOTORS dealer.
 If the UNLOCK switch on the key, the
driver's or front
lock/unlock switch is pressed and no door or
the tailgate is opened within 30 seconds, the
doors and the tailgate will automatically
relock. In this case as well, the system prepa-
ration mode will go into effect.
 The time between pressing of the UNLOCK
switch on the key, the driver's or front pas-
senger's door lock/unlock switch and auto-
matic locking can be adjusted. Please consult
an authorised MITSUBISHI
dealer.
Alarm activation
When the system is in the system armed
mode, the alarm will be activated as follows
if the vehicle is unlocked or if any of the
doors or tailgate is opened using a method
other than the keyless entry system or the
keyless operation function.
Locking and unlocking
3
passenger's door
MOTORS
E00301902785
3-21