Mitsubishi XPANDER HEV 2023 Manual page 96

NOTE
 When multiple warnings occur simultane-
ously, all warnings can be displayed by using
the Up/Down switch.
 Function setting display
"Display type", "Sub unit speedometer",
"Driver Assistance", "Rest reminder", "Turn-
signal sound", "Operation sound", "Lan-
guage", "Unit", "Maintenance", "Factory
reset", etc. can be changed to the setting of
your choice.
Please follow the procedure below.
1. Stop the vehicle in a safe place. Apply the
Electric parking brake and put the select
position in the "P" (PARK) position.
2. Press the Left switch or Right switch to
select the function setting display from
the multi information screen. Refer to
"Multi information screen" on page 5-9.
CAUTION
 For safety, stop the vehicle before operating.
You can not change the setting while driv-
E00578100235
ing.
3. Operate the Up/Down switch to select the
desired setting item.
Please read each item about detailed set-
ting method.
Refer to "Changing the display type set-
ting" on page 5-11.
Refer to "Changing the sub unit speedom-
eter display" on page 5-12.
Refer to "Active stability control (ASC)"
on page 6-37.
Refer to "Changing the time until "REST
REMINDER" is displayed" on page 5-12.
Refer to "Changing the turn-signal sound"
on page 5-12.
Refer to "Operation sound setting" on
page 5-12.
Refer to "Changing the display language"
on page 5-13.
Refer to "Changing the fuel consumption
display unit and the temperature unit" on
page 5-13.
Refer to "Service reminder" on page 5-16.
Instruments
Refer to "Returning to the factory set-
tings" on page 5-13.
NOTE
 To return menu screen to the function setting
display, press the Back switch.
 If the auxiliary battery is disconnected, these
function settings are automatically reset to
factory settings from memory (except the
"Driver Assistance" and "Maintenance" set-
tings).
 Changing the display type setting
You can change the display type to the screen
display of your choice.
1. Change to function setting display.
Refer to "Function setting display" on
page 5-11.
2. After selecting "Display Type" (display
type setting), press the Enter switch to
change the display type.
NOTE
 When you remove the auxiliary battery ter-
minal, the screen switches to Type 1.
Instruments and controls
5
E00578200063
5-11